MODEL 190CLR

Driving Belt – “B” section V-belt.

Bed – Roller bed width between frames, 15″, 21″, 27″, 33″ and 39″. 2-1⁄2″ diameter tapered to 1-11⁄16″ diameter x 14 gauge wall plated tread rollers. 7⁄16″ hex shafts. Steel pressure sheaves. Mounted in 7″ x 1-1⁄2″ x 12 gauge powder painted formed steel channel frame.

Floor Supports – Adjustable 31-1⁄2″ to 45-1⁄2″ from floor to top of rollers. One support at each end, and center leg on the outer rail.

Take-Up – Screw take-up provided to ensure proper V-belt tension. Mounted underneath the conveyor.

Tangent – 12″ long, one on each end.

End Drive – Mounted below bed section.

Bearings– Sealed pre-lubricated with cast iron housings.

Speed Reducer – C-Face mounted heavy duty worm gear reducer.

Motor – 1⁄2 HP 230/460-3-60 TE motor.

Belt Speed – 60 FPM constant.

Capacity – 540 Ibs. total distributed live load.

Guard Rails – Adjustable channel, continuous channel, steel guard rails available.

Floor Supports – Lower or higher supports are available. Minimum elevation, 17″ from floor to top of rollers. Ceiling Hangers – 1 ⁄2″ diameter threaded rods 8 feet long with locking nuts and mounting hardware. Other lengths are available.

Side Mounted Drive – The end drive is mounted to the side of the conveyor bed section. Minimum elevation 9-1⁄2″. Specify side.

Motor – Single phase, energy-efficient, explosion-proof, etc. Other HP is available.

Belt Speed – Constant and variable belt speeds are available.

Electrical Controls – Magnetic starters and push-button stations; manual motor starters with overload protection, others.

Tangents – Standard tangents are 12″ long, located at each end of the curve. Longer tangents are available. Contact Factory.