MODEL 190CLRS

Driving Belt – “B” section V-belt.

Bed – Roller bed width between rails 15″, 21″, 27″, 33″ and 39″. 7-1/2″ x 1-1/2″ x 12 gauge powder painted formed steel channel frame.

Tread Rollers – 2-1/2″ diameter tapered to 1-11/16″ diameter plated and 1.9″ diameter x 16 gauge plated steel tread rollers, 7/16″ hex shaft.

Pressure Sheaves – 3″ diameter x 3/8″ bore, adjustable to give required driving force.

Take-Up – Screw take-up provided to ensure proper V-belt tension. Mounted underneath conveyor.

Tangent – 12″ long, on one end of curved spur.

Floor Supports – Adjustable 31-1/2″ to 45-1/2″ from floor to top of rollers.

End Drive – Mounted below bed section.

Bearings – Sealed pre lubricated with cast iron housings.

Speed Reducer – C-Face mounted heavy duty worm gear reducer.

Motor – 1/2 HP 230/460-3-60 TE motor.

Belt Speed – 60 FPM constant.

Capacity – 540 Ibs. total distributed live load.

Guard Rails – Adjustable channel, continuous channel,steel guard rails available.

Floor Supports – Lower or higher supports are available. Minimum elevation, 17″ from floor to top of rollers.

Ceiling Hangers – 1⁄2″ diameter threaded rods 8 feet long with locking nuts and mounting hardware. Other lengths are available.

Center Drive – Mounted underneath bed section in center of spur.

Side Mounted Drive – End drive mounted to side of conveyor section. Specify side. Minimum elevation – 9-1⁄2″ from floor to top of rollers.

Motor – Single phase, energy efficient, explosion proof, etc. Other HP available.

Belt Speed – Constant and variable belt speeds available.

Electrical Controls – Magnetic starters and push button stations; manual motor starters with overload protection, others.