MODEL 190LSE

Driving Belts – 3⁄16″ diameter round urethane “O” rings from drive shaft to tread rollers.

Bed – 7″ x 1-1⁄2″ x 12 gauge powder painted formed steel channel frame with heavy duty cross braces and splice plates.

Rollers – 1.9″ diameter x 16 gauge galvanized steel tread rollers with 7⁄16″ hex shaft and sealed, greased for life bearings, spaced on 3″ centers.

Sensing Device – NEMA 1 photoelectric sensor in each zone detects presence of product and activates accumulation feature in the trailing zone if upstream zone is occupied.

Power Supply – 120 VAC power supply controls accumulation feature with 24 VDC output. Power supply will control 50 accumulation zones.

Air Requirements – 20 to 35 psi recommended operating pressure with free air consumption of .0062 cu. ft. per sensor operation.

Accumulation Zones – 24″, 30″, or 36″ long, air operated. Conveyor frame length changes with zone lengths. Note: Zone length must be evenly divisible by roller centers.

Filter/Regulator – Supplied loose for mounting to conveyor side frame, with 3⁄8″ NPT ports.

Guard Rails – 1-1⁄2″ x 1-1⁄2″ x 12 gauge galvanized guard rails – both sides. NOTE: Product contact with guard rails will affect product flow.

Floor Supports – Adjustable 31-1⁄2″ to 45-1⁄2″ from floor to top of tread roller. One support supplied at each end of conveyor and at each bed joint.

Drive – 2 foot module with motor and reducer. Drive module will be bolted to intermediate section.

Drive Shaft – 1″ diameter steel shaft, driven by motor and reducer, runs full length of conveyor. Chain coupling supplied at bed joints to couple sections together.

Drive Spools – Delrin spools located on drive shaft supplies driving power to tread rollers.

Drive Shaft Bearings – Sealed, pre lubricated, self-aligning, precision ball bearings on drive shaft.

Speed Reducer – C-Face mounted heavy duty worm gear reducer.

Motor -1⁄2 HP 230/460/3-60 TE motor.

Drive Guard – Expanded metal guard full length of conveyor covers drive shaft and other moving drive components.

Conveying Speed – 60 FPM constant.

Capacity – 15 lbs. per tread roller maximum.

Conveying Speed – Constant and variable speeds from 30 to 120 FPM available.

Timing Belt Drive – For speeds 90 FPM and above a timing belt drive in lieu of #50 chain drive is recommended.

Roller Centers – 2-1⁄4”, 4”, 6”, or 8” centers. NOTE: Capacities change as roller centers change. See engineering section of price list for capacity changes.

Accumulation Zones – 18”long, air operated. Conveyor frame lengths change with zone lengths. NOTE: Zone length must be evenly divisible by roller centers.

Floor Supports – Lower or higher supports available. Minimum elevation with standard drive mounting is 18″ from floor to top of rollers.

Powered Right Angle Belt Transfer – Air operated pop-up round belt transfer mounted in 32″ long modular section, 75 lbs. maximum unit load.- Reversing UBT is 39″ long.

Package Stops – Manual or air operated, blade or roller stops available.

Slug Release – Allows for conveyor to be quickly unloaded when accumulation feature is not required.

Motor – Single phase, energy efficient, explosion proof, etc. Other HP available.

Ceiling Hangers – 1⁄2″ diameter threaded rods 8 feet long with locking nuts and mounting hardware.

Jump Chain – One-to-one chain drive moves drive shaft to opposite side for driving various optional accessories.