MODEL 190RB

Belt – 12″, 18″, 24″, 30″, 36″, 42″ and 48″ Black PVC 120 belt.

Bed – Roller bed with 1.9″ diameter galvanized steel rollers. Rollers spaced on 6″ centers. Rollers mounted in 7″ deep x 12 gauge powder painted formed steel channel frames. Frames bolted together with butt couplings and floor supports.

X-Bracing – Frame squaring device supplied on conveyors 40 feet and longer for every other bed section. X-bracing insures good product and belt tracking.

Drive Pulley – 8″ diameter crowned and fully lagged, 1-7/16″ shaft.

Tail Pulley – 4″ diameter crowned supplied through 30″ wide belts. 6″ diameter crowned supplied for 36″ and wider belts. 4″ diameter pulley has 1-3/16″ diameter shaft; 6″ diameter pulley has 1-7/16″ diameter shaft turned down on ends to 1-3/16″ diameter.

Pop-Out Roller – 1.9″ diameter roller, Iocated at drive pulley and tail pulley.

Snub Roller – 2-1/2″ diameter adjustable roller, Iocated directly behind drive pulley, 2″ diameter located behind tail pulley.

Return Rollers – 1.9″ diameter adjustable on 10’0″ centers.

Take-Up – Located at tail end, provides 12″ of belt take-up.

Bearings – Sealed-pre-lubricated with cast iron housings.

Floor Supports – Adjustable 31-1/2″ to 45-1/2″ from floor to top of belt. One support supplied at each end of conveyor and at each bed joint.

Speed Reducer – C-Face mounted heavy duty worm gear reducer.

Motor – 1/2 HP 230/460-3-60 TE motor.

Belt Speed – 60 FPM constant.

Capacity – 200 pounds per foot maximum.

Belt – Nitrile (white or black) with smooth top cover, Black PVC rough top, Brown Nitrile rough top. Special belts on application.

Roller Centers – 1.9″ diameter galvanized steel rollers spaced on 3″, 4- 1⁄2″, 9″ or 12″ centers.

Guard Rails – Adjustable channel, continuous channel, or solid steel guard rails available.

Floor Supports – Lower or higher than standard. Castered supports with 4″ diameter or 6″ diameter rigid or swivel casters.

Ceiling Hangers – 1⁄2″ diameter threaded rods 8 feet long with locking nuts and mounting hardware. Other lengths are available.

Nose-Over – Adjustable single or double nose-over provides smooth transfer from incline to horizontal.

Side Mounted Drive – End drive mounted to side of conveyor section. Specify side. Minimum elevation – 10″.

Center Drive – Mounted below conveyor bed section. Can be placed most anywhere in conveyor length.

Auxiliary Take-Up – Mounted below conveyor bed section. Can be placed most anywhere in conveyor length.

Motor – Single phase, energy efficient, explosion proof, etc. Other HP available.

Belt Speed – Constant and variable belt speeds available.

Electrical Controls – Magnetic starters and push button stations; manual motor starters with overload protection, others.

Power Feeder – Separate belt section with (2) MD-6 (28- 1⁄2″ to 42- 1⁄2″ adjustable) supports. Feeder driven by roller chain from main conveyor. Auxiliary take-up required on inclined conveyor. Integral feeder available.