MODEL 190RBI

Contact for purchase
190RBI Conveyor

INCLINED ROLLER BED CONVEYOR

Applications / Features:

  • Transporting Between Floors

  • Booster Conveyor for Gravity Flow Systems

  • Heavier Loads Can be Conveyed Because of Less Friction Build-up

  • Belt – 12″, 16″, 18″, 20″, 24″ and 30″ wide rough-top belt.

    Bed – Roller bed with 1.9″ diameter x 16 gauge galvanized rollers spaced on 6″ centers. Rollers mounted in 7″ x 1-1/2″ x 12 gauge powder painted formed steel channel frames. Frames bolted together with butt couplings.

    Under-Trussed Bed – Extra reinforcement to prevent sag in longer bed sections in addition to reinforcing angles, 20 feet and longer.

    X-Bracing – Supplied on conveyors 40 feet and longer. Used to square bed sections to insure proper product and belt tracking.

    Double Nose-Over – Adjustable from 0° to 30°.

    Center Drive – Mounted below conveyor bed section. Can be placed most anywhere in conveyor length.

    Tail Pulley – 4″ diameter, crowned with 1-3/16″ diameter shaft through 30″ wide belt. 6″ diameter tail pulley with 1-7/16″ diameter shaft turned down on ends for wider than 30″ belt.

    Drive Pulley – 8″ diameter and fully lagged, 1-7/16″ diameter shaft.

    Snub Roller – 2-1/2″ diameter at drive pulley, 2″ diameter at terminal pulleys.

    Return Roller – 1.9″ diameter.

    Take-Up – Located in center drive, provides 24″ of belt take-up.

    Gravity Brackets – Adjustable rod with 1-3/8″ diameter pop-out transfer roller to attach wheel or 1-3/8″ diameter roller conveyor.

    Bearings – Sealed pre-lubricated with cast iron housings.

    Floor Supports – Adjustable 31-1/2″ to 45-1/2″ from floor to top of belt. One support supplied at each end of conveyor and at noseover, with knee braces.

    Speed Reducer – C-Face mounted heavy duty worm gear reducer.

    Motor – 3/4 HP 230/460-3-60 TE motor.

    Belt Speed – 60 FPM constant.

  • Belt – Neoprene ruff-top, PVC rough-top, other types and styles.

    Guard Rails – Adjustable channel, continuous channel, or solid steel guard rails available.

    Ceiling Hangers – 1⁄2″ diameter threaded rods 8 feet long with locking nuts and mounting hardware. Other lengths are available.

    Floor Supports – Lower or higher than standard.

    Lower Powered Feeder Section – Separate belt section with (2) supports, adjustable from 28-1⁄2″ to 42-1⁄2″. Driven by roller chain from tail pulley of inclined section. Integral feeders available.

    Motor – Single phase, energy efficient, explosion proof, etc. Other HP are available.

    Belt Speed – Constant and variable belt speeds available.

    Electrical Controls – Magnetic starters, push button stations; manual motor starters with overload protection, others.

    Single Noseover – Available.