MODEL 251ACDA

Frame — Heavy duty 7" deep x 4 gauge powder painted formed steel channel with heavy duty cross braces. Frames are bolted together with splice plates and floor supports.

Rollers — 2½" diameter x 11 gauge steel rollers, grease packed and labyrinth sealed bearings, 11⁄16" hex shaft. Rollers are spaced on 4" or 6" centers, set 2¼" low.

Floor Supports — Adjustable 18¾" to 233⁄8" (HD-4) from floor to top of roller, for each end of conveyor and at each bed joint along with knee braces for each support. Supports on 5 foot centers, changes with zone length.

Drive — Located near center of conveyor length, shaft mount motor and reducer.

Drive Chain — RC 40 chain used for roller-to-roller connections, RC 60 chain drive each zone. Chains are totally enclosed by metal guards.

Accumulation Zones — Standard zones are 60" long with a maximum of 30 zones per single drive. Each zone is driven by an air clutch and controlled by a sensor roller.

Motor — ¾ HP 230/460-3-60 TE motor.

Electrical Controls — 110/1/60 Electric Solenoid and Air switch for discharge zone.

Conveyor Speed — 30 FPM constant roller speed.

Capacity — Minimum unit load - 50 lbs. 4,000 lbs. Maximum unit load. Total conveyor live load not to exceed Load Capacity Chart. For loads less than 50 lbs., consult factory.

Speed Reducer — Heavy duty, sealed worm gear, C-Face.

Bearings — Sealed pre-lubricated with cast iron housings.