MODEL 251ACDE

Frame – Heavy duty 7″ deep x 4 gauge powder painted formed steel channel with heavy duty cross braces. Frames are bolted together with splice plates and floor supports.

Rollers – 2-1/4″ diameter x 11 gauge steel rollers, grease packed and labyrinth sealed bearings, 11/16″ hex shaft. Rollers are spaced on 4″ or 6″centers, set 2-1/4″ low.

Floor Supports – Adjustable 18-3/4″ to 23-3/8″ (HD-4) from floor to top of roller, for each end of conveyor and at each bed joint along with knee braces for each support. Supports on 5 foot centers, changes with zone length.

Drive – Located near center of conveyor length, shaft mount motor and reducer.

Drive Chain – RC #40 chain used for roller to roller connections, RC #60 chain drives each zone. Chains are totally enclosed by metal guards.

Accumulation Zones – Standard zone lengths are 60″ long with a maximum of 30 zones per single drive. Each zone is driven by an air clutch and controlled by a photo eye sensor.

Motor – 3/4 HP 230/460-3-60 TE motor.

Electrical Controls – 120 VAC input to power supply.

Conveyor Speed – 30 FPM constant roller speed.

Capacity – 4000 pounds maximum unit load.

Speed Reducer – Heavy duty, sealed worm gear, C-Face.

Bearings – Sealed pre-lubricated with cast iron housings.

Sensing Device – NEMA 1 photoelectric sensor in each zone detects presence of product and activates accumulation feature in trailing zone if upstream zone is occupied.

Power Supply – 120 VAC power supply controls accumulation feature with 24 VDC output. Power supply will control 50 accumulation zones.

Accumulation Zones – 4″ roller centers – 36″, 40″, 44″, 48″, 52″, 56″ and 72″ long. 6″ roller centers 36″, 42″, 48″, 54″ and 72″ long. Frame lengths change with zone lengths.

Tread Rollers – 25 ⁄8″ diameter x 7 gauge steel, 11⁄16″ hex shaft.

Floor Supports – Higher or lower supports available, adjustable or fixed type. Conveyor Speed – Constant and variable speeds (Contact Factory).

Limit Switch – to provide signal for customers infeed equipment.

Time Delay – Allows for product to be unloaded from discharge zone of conveyor without movement of next load into discharge zone.

Motor – Single phase, energy efficient, explosion proof, etc.Other HP available.

Electrical Controls – Magnetic starters and push button stations; Manual motor starters with overload protection, others. 24V DC solenoid can be supplied in lieu of 110V AC solenoid in discharge zone.

Optional Loads – Larger capacity clutch is available for 6000 lb. unit loads.

Reversible – can be supplied with reversing feature to allow accumulation in both directions.