MODEL 251CDE

Frame — Heavy duty 12½″ deep x 7 gauge powder painted formed steel channel with heavy duty cross braces. Frames are bolted with splice plates and floor supports.

Rollers — 2½″ diameter x 11 gauge steel rollers, grease packed and labyrinth sealed bearings, 11⁄16″ hex shaft. Rollers are spaced on 4″ or 6″ centers, set 7⁄8″ low.

Floor Supports — Adjustable 25⅝″ to 30¼″ (HD-4) from floor to top of roller, for each end of conveyor and at each bed joint along with knee braces for each support. Supports on 5 foot centers, change with zone length. Minimum elevation with standard drive location 24″.

Drive — Located near center of conveyor length, underneath conveyor frame.

Drive Chain — RC #40 chain used for roller-to-roller connections, RC #60 chain drives each zone. Chains are totally enclosed by metal guards.

Accumulation Zones — Standard zone lengths are 60″ long with a maximum of 30 zones per single drive. Each zone is controlled by photo eye.

Sensing Device — NEMA 1 photoelectric sensor in each zone detects presence of product and activates accumulation feature in the trailing zone if upstream zone is occupied.

Motor — ¾ HP 230/460-3-60 TE motor.

Electrical Controls — 120 VAC input power supply. Power supply has an output of 24 VDC, 4 amp maximum.

Power Supply — 120 VAC power supply controls accumulation feature with 24 VDC output. Power supply will control 50 accumulation zones.

Conveyor Speed — 30 FPM constant roller speed.

Capacity — Minimum unit load — 50 pounds. 4000 pounds maximum unit load. Total conveyor live load not to exceed Load Capacity Chart (see catalog page). For loads less than 50 lbs. you must consult factory.

Speed Reducer — Heavy duty, sealed worm gear, C-Face reducer.

Bearings — Non-reversing sealed pre-lubricated with cast iron housing.

Filter/Regulator — Mounted to conveyor side frame. 50 PSI recommended operating pressure with free air consumption of .001 cu. ft. per sensor operation.