MODEL DC

Frame – 9″ x 7 gauge powder painted formed steel channel frames. Sections are bolted together with splice plates and floor supports.

Chain – (2) 60F single pitch conveyor chains, straight side bar, on 36″ centers.

Chain Guide – UHMW.

Floor Supports – 24″ to top of chain. One support supplied at each end of conveyor and at each bed joint.

Motor – 1 HP 230/460-3-60 TE motor, C-Face. Motor and speed reducer are located underneath conveyor frame.

Speed Reducer – Heavy duty worm gear for C-Face mounted motor.

Sprockets – Hardened sprockets with 1-15/16″ diameter CRS drive shaft.

Bearings – Sealed, pre-lubricated with cast iron housing.

Speed – 30 FPM constant speed.

Capacity – 10,000 lbs. maximum distributed live load at 30 FPM. Maximum motor size is 3 HP. Not to exceed Load Capacity Chart.

Elevation – 12” minimum (with adjustment to 13”) to top of chain, made available by modification. Contact factory.

Motors – Single phase, energy efficient.

Chain Centers – Other chain centers and multiple chains available, 18″ minimum chain centers. Contact factory.

Speeds – For speeds greater than 30 FPM, contact factory.

Electrical Controls – Magnetic starters and push button stations; manual motor starters with overload protection, others.