MODEL FTC

Belt – 14″, 18″, 24″, 30″ and 36″wide rough-top belt.

Bed – 20″, 24″, 30″, 30″, 36″ and 42″ wide 12 gauge powder painted formed steel slider bed. Bed is 6-1/2″ deep x 6 feet, 8 feet or 10 feet long spliced together with splice plates.

Under-Trussed Bed – Extra reinforcement to prevent sag in longer bed sections in addition to reinforcing angles, 24 feet and longer.

Double Nose-Over – Two 16″ long adjustable bed sections provide a two step transition from incline to horizontal with 15° to 35° adjustment.

Tail Pulley – 4″ diameter, crowned with 1-3/16″ diameter shaft through 30″ wide belt. 6″ diameter tail pulley with 1-7/16″ diameter shaft turned down on ends for wider than 30″ belt.

Drive Pulley – 8″ diameter crowned and lagged. 1-7/16″ diameter.

Snub Roller – 2-1/2″ diameter at drive pulley and 2″ diameter at tail pulley.

Return Idlers - 1.9″ diameter, adjustable.

Take-Up – Located in center drive assembly, provides 24″ of belt take-up.

Pop-Out Roller – Free floating, 1-3/8″ diameter rollers located at tail pulleys with gravity connector rods. Will lift out if anything is caught between pulleys and rollers.

Floor Supports – Adjustable stands to give 31″ to 45″ height at each end;with knee braces.

Bearings – Sealed pre lubricated with cast iron housings.

Speed Reducer – C-Face mounted heavy duty worm gear reducer.

Motor – 3/4 HP 230/460-3-60 TE motor.

Belt Speed – 60 FPM constant.

Capacity – 100 lbs. per foot maximum.

Belt – Neoprene ruff-top, PVC rough-top, other types and styles.

Guard Rails – Adjustable channel, continuous channel, or solid steel guard rails available.

Ceiling Hangers – 1⁄2″ diameter threaded rods of 8 feet long with locking nuts and mounting hardware. Other lengths are available.

Floor Stands – Lower or higher than standard.

Lower Powered Feeder Section – Separate belt section with (2) supports, adjustable from 28-1⁄2″ to 42-1⁄2″. Driven by roller chain from tail pulley of inclined section. Integral feeder available.

Single Nose - Over – A straight section 23-1⁄2″ from tail pulley to center of nose-over roller provides for smooth transition from 0° to 15° incline.

Motor – Single phase, energy efficient, explosion proof, etc. Other HP available.

Belt Speed – Constant and variable belt speeds available.

Electrical Controls – Magnetic starters and push button stations; manual motor starters with overload protection, others