MODEL MPB

Belt Width – 12″, 18″, 24″, 30”, and 48″ wide, 1″ grey polypropylene thermoplastic modular belt.

Bed – 7″ deep x 12 gauge powder painted formed steel channel frames set low with guard. Bolt-in formed steel pan with UHMW carrying surface.

End Drive – End drive standard.

X-Bracing -Frame squaring device supplied on conveyors 40 feet and longer for every other bed section. X-bracing insures good product and belt tracking.

Sprockets – 5.8″ pitch diameter x 1.5″ square bore, molded polyamide thermoplastic.

Return Idlers – UHMW rollers located along overall length for proper belt tension.

Take-up – Belt take-up is done with belt (catenary) sagging.

Bearings – Sealed and prelubricated with cast iron housings.

Floor Supports – Adjustable 30-3 ⁄4″ to 443 ⁄4″ from floor to top of belt. One support supplied at each end of conveyor and at each bed joint.

Speed Reducer – C-Face mounted heavy duty worm gear reducer

Motor – 3/4 HP 230/460-3-60 TE motor.

Belt Speed – 60 FPM constant.

Capacity – 200 pounds per foot maximum.

Belt – Various styles (colors & materials) available – contact factory.

Sprockets – Other pitch diameters available.

Guard Rails – Adjustable channel, continuous channel, or solid steel guard rails available.

Floor Supports – Lower or higher than standard. Castered supports with 4″ diameter or 6″ diameter rigid or swivel casters.

Ceiling Hangers – 1 ⁄2″ diameter threaded rods 8 feet long with locking nuts and mounting hardware. Other lengths are available.

Motor – Single phase, energy efficient, explosion proof, etc. Other HP available.

Belt Speed – Constant and variable belt speeds available.

Electrical Controls – Magnetic starters, push button stations; manual motor starters with overload protection, others.