MODEL SBT

Contact for Purchase
Slider Bed Trash Conveyor

SLIDER BED TRASH CONVEYOR

Applications / Features:

  • Adjustable floor supports

  • Incline to 15′

  • Guard rails

  • Economical

  • Bed – 5-1/2″ deep x 14 gauge powder painted formed steel channel frame. Bed sections are 10 feet and 5 feet long, bolted together with splice plates and floor supports.

    Belt – 12″, 18″, 24″, 30″, 36″, 42″ and 48″ wide, black PVC 120, FS x FS.

    Guard Rail – 6″ high x 16 gauge formed, powder painted steel on both sides, full length of bed sections.

    Underside Guards – Formed 16 gauge pans full length of bed sections, removable, secured with TEK screws.

    Tail Pulley – 4″ or 6″ diameter (see chart) crowned with 1-3/16″ diameter shaft.

    Drive Pulley – 4″, 6″ and 8″ diameter crowned and fully lagged. 4″ and 6″ diameter pulleys have 1-3/16″ diameter shaft, 8″ diameter pulley has 1-7/16″ diameter shaft.

    Snub Roller – 2″ diameter (for 4″ and 6″ diameter drive pulleys), 2-1/2″ diameter (for 8″ diameter drive pulley).

    Return Rollers – 1.9″ diameter placed on 10′ centers.

    Floor Supports – Adjustable 30″ to 44″ from floor to top of belt. One floor support provided at each end of conveyor and at each bed joint.

    Take-Up – 6″ long screws located at tail pulley to provide belt tension.

    Bearings – Sealed, prelubricated with cast iron housings.

    Speed Reducer – C-Face mounted heavy duty worm gear reducer.

    Motor – 1/2 HP 230/460-3-60 TE motor.

    Capacity – 10 pounds per foot maximum live load.

  • Guard Rails – 12″, 18″, or 4″ high; vertical or 30 degree flare, for one or both sides.

    Floor Supports – Higher than standard supports available to 121″.

    Ceiling Hangers – 1⁄2″ diameter threaded rods, 8 feet long with locking nuts and mounting hardware.

    Nose-Over – Fixed single nose-over at 10, 121⁄2 or 15 degrees. Adjustable nose-over roller for belt tracking.

    Center Drive – Mounted below conveyor bed section. Can be placed most anywhere in conveyor length.

    Auxiliary Belt Take-Up – Mounted below conveyor bed section. Can be placed most anywhere in conveyor length.

    Side Mounted End Drive – Mounted to side of conveyor bed.

    Minimum elevations: 4″ pulley – 7 1⁄2″, 6″ pulley – 8 1⁄2″, 8″ pulley -10 1⁄2″. Specify side.

    Two Pulley Hitch – For transferring material from horizontal to incline section.

    Inline Transfer Unit – For transferring material from one horizontal conveyor to another.

    Belt – #100 PVC rough top belt for incline applications.

    Belt Speed – 45, 75, 90 and 120 FPM. Please specify.

    Motor – Single phase, energy efficient, explosion proof, etc. Other HP available.